Urine analyzer is determination of some of the
chemical composition of urine automation medical devices. It is important tool
of the medical laboratory to check the urine. By Perlong Medical PUY-1688 urine analyzer, for
example, it has simple operation, fast.
So what shall we pay attention of using the urine analyzer ?
1, Must read the instructions carefully, use the equipment before, detailed understanding of instruments work principle, operation method, note, calibration methods and equipment maintenance requirements.
2, The instrument should be installed in the far away from the electromagnetic interference sources, heat source, prevent sun, damp, ventilated good test bench, indoor temperature should be in 15 to 25 degrees, relative humidity should be < 80%.
3, After the start of a tape measure, calibration and the testing results and the tape is completely consistent only in the quality control of material or urine samples of detection.
4 , Four quality controls, normal and abnormal urine test, if the "normal" quality control results are abnormal, or "abnormal" control results of the change of normal out of control. If a film control blocks (project) in the target + 1, etc, not yet out of control a treat.
5, Urine test and control in allowing range, can undertake urine samples, the requirements of the inspection urine specimens fresh, emission testing the longest no more than 2 hours. If not check in time, should be set to 4 ℃ specimen of not more than six hours for. When test urine samples after the refrigerator, should make its balance temperature to room temperature before mixed experiment.
6, Urine dipstick should be in the manufacturer recommends storage conditions and use, should not attempt to direct contact in the sunlight or exposed to wet environment. A belt article required test, and should be replaced immediately cover. Redundant test should not be returned to the original container, but not bottle the rest of the article test. Business does not contact with reaction inspection module.
So what shall we pay attention of using the urine analyzer ?
1, Must read the instructions carefully, use the equipment before, detailed understanding of instruments work principle, operation method, note, calibration methods and equipment maintenance requirements.
2, The instrument should be installed in the far away from the electromagnetic interference sources, heat source, prevent sun, damp, ventilated good test bench, indoor temperature should be in 15 to 25 degrees, relative humidity should be < 80%.
3, After the start of a tape measure, calibration and the testing results and the tape is completely consistent only in the quality control of material or urine samples of detection.
4 , Four quality controls, normal and abnormal urine test, if the "normal" quality control results are abnormal, or "abnormal" control results of the change of normal out of control. If a film control blocks (project) in the target + 1, etc, not yet out of control a treat.
5, Urine test and control in allowing range, can undertake urine samples, the requirements of the inspection urine specimens fresh, emission testing the longest no more than 2 hours. If not check in time, should be set to 4 ℃ specimen of not more than six hours for. When test urine samples after the refrigerator, should make its balance temperature to room temperature before mixed experiment.
6, Urine dipstick should be in the manufacturer recommends storage conditions and use, should not attempt to direct contact in the sunlight or exposed to wet environment. A belt article required test, and should be replaced immediately cover. Redundant test should not be returned to the original container, but not bottle the rest of the article test. Business does not contact with reaction inspection module.
Article : From perlong medical (http://www.pl999.net)
没有评论:
发表评论